Hi,
I have a Riemo conversion with a Heatsource 1600 gas heater in it with an adjustable thermostat on it.
The thermostat doesnt seem to be working as when it is turned to the cool position the heater doesn't cut out, then cut back in when the temperature drops.
Has anyone else had this problem? how can I test it? Where will I get a new one if I need to replace it?
Thanks for your help,
Scottie
Heatsource 1600 Thermostat
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 2
- Joined: 14 Oct 2006, 06:28
- 80-90 Mem No: 0
- Location: Rochester in Kent, England
- Contact:
Heatsource 1600 Thermostat
Home is a place to be.......when there's no where better to go!!
-
- Registered user
- Posts: 2
- Joined: 14 Oct 2006, 06:28
- 80-90 Mem No: 0
- Location: Rochester in Kent, England
- Contact:
I found it :o)
Thanks Futurecut,
I have not been using this forum for long and posted the question before looking for the answer!!
I did a search and it did show that there had been a previous post.
I don't know much about electrics but I do have the wiring diagram now so i'll see if I can get someone to fit it for me.
Cheers,
Scottie
I have not been using this forum for long and posted the question before looking for the answer!!
I did a search and it did show that there had been a previous post.
I don't know much about electrics but I do have the wiring diagram now so i'll see if I can get someone to fit it for me.
Cheers,
Scottie
Home is a place to be.......when there's no where better to go!!