Club 80-90 Forums

Is there a secret to peeling the rubber from the plastic strip. Apart from lots of swearing and 10 mins of faffing.

No!

I suspected as much.

Have you got any anti amalgamation gel

No, but I will endeavour to buy some.

I have struggled with it for years.
The best way that I have found is to to cut a piece with a craft knife but only cut half way across then pull to snap the backing and tape. This way the two can be stretched and wrinkles form that can be used to separate the two. If you are lucky a quick score across the backing with a craft knife will just cut the backing. Here are a couple of cuts that I have just done:

I will give that a try next time I use some. Thanks mate.

I always stretch it and the tape stretches but the backing wont

I must have different tape as both the rubber and backing stretch.

Mine has a plastic type of backing , its does stretch but not nearly as much as the tape .

R0B wrote: ↑19 Mar 2023, 16:43 Is there a secret to peeling the rubber from the plastic strip. Apart from lots of swearing and 10 mins of faffing.

yes

Been using it for many years. My trick is to pull at the edge of a corner, literally the last couple of mm. The tape grips your finger better than the shiny backing and comes apart. But mine does have a smooth plastic backing tape, yours may be different.

Some tapes are easier than others I found, even tried heating the corner gently with a lighter to try and separate them.