Club 80-90 Forums

Posted: **21 Jun 2023, 10:13**

Hello,

I am now undertaking refitting 'new' (2nd hand) Sliding door seals, and does anyone know, or can provide photos, of the correct orientation? There is quite a lot of contrasting information regarding the 5-inch flap section on one of the upright sections of the seal - I have seen it placed at the front latch, and the rear latch..

Any help appreciated

Posted: **21 Jun 2023, 10:28**

Lewis and Bee wrote: ↑21 Jun 2023, 10:13 Hello,

I am now undertaking refitting 'new' (2nd hand) Sliding door seals, and does anyone know, or can provide photos, of the correct orientation? There is quite a lot of contrasting information regarding the 5-inch flap section on one of the upright sections of the seal - I have seen it placed at the front latch, and the rear latch..

Any help appreciated

At the back, you’ll see when you close the door it fits around the back of the door , make sure
You have a RHD one

Posted: **21 Jun 2023, 13:23**

Ok, super so is it like this?...
I feel it should sit a little lower, but the length of the rubber dictates to height, so i guess its right?...

There are still sources online which suggest it goes a the front. Most confusing

Club 80-90 Forums

Cab and Sliding Door Closures

Re: Cab and Sliding Door Closures

Re: Cab and Sliding Door Closures

Re: Cab and Sliding Door Closures