Club 80-90 Forums

Hi
Would like a bit of advice on my CV driveshaft, last year had the whole driveshaft replaced after having a knocking from the rear drivers side ,all well untill coming home from a trip and noticed a knocking again when I went around a roundabout and when I took a right turn,
now been doing a bit of research and it maybe loose bolts (6 spline ) or maybe grease dried up ?
so im going to try and tighten them and see if thats my problem,
but would a drive shaft after say 2000 miles fail this early ? or could it be a cheap inferior replacement fitted ? or could it be something else failing ?
and if it is the driveshaft what does anyone suggest change both sides (whole shafts) at the same time ?
and whats the best ones to purchase , was looking at the brickwerks ones at £180 each, as I don't mind paying for good quality
appreciate your views folks

Always good stuff from Brickwerks,cheep joints are cheep for a reason,grease shouldn’t dry up,if it’s a year old return under warranty

The thing is I was away in Devon and had to go to the nearest garage to get it replaced ,they changed the whole thing but don't know what one they replaced it with , so could be a cheap one , it cost me about £240 fitted, didn't have a choice really I was on holiday .....

Might still be worth contacting them to ask,photo of mileage video of knackered driveshaft in situ,nice polite non threatening letter,estimate for replacing and see what they think