Club 80-90 Forums

'84 LT25 petrol 1.9
Taken starter battery out of van and charged it up. When fully charged it showed 13.33v yesterday. Today it shows 12.90v. As it is still out of van so there is no drain on it, is the battery on the blink.
Thanks

'84 1.9 LT25 Camper Van
Is there a sequence for replacing the accelerator cable, any problems to watch out for.
Thanks

'84 LT25 1.9 Camper
I have alloys with 195/70 R 15 C tyres. What should the correct pressures be, front and back. The tyre itself states 'cold 65psi' which seems very high, having been to a tyre place for new valves they have set the pressures at 40psi.
Regards

'84 LT25 1.9
I am getting a lot of water inside at the back either side of the engine cover. The only thing I can put it down to is water is getting in between the pop top where it sits on the gutter. What is the best sealant to use to cure the problem.
Regards

The three fixings that hold the splash plate, is there enough room to fit three hex head screws?

Many thanks

I have a splash plate missing. I am getting a replacement and need to know the size and length of the three Philips? head screws that hold It on
Thanks

Thanks for the comments. I am putting longer studs on hub.

Many thanks

Is thread on nut anti-clockwise to undo?

Can anyone advise me the torque setting for the castelated nut for the rear wheel hub.
Thanks

Thanks for the info.

These wheels were on the vehicle when I bought it last July. Have had no problems driving round France. Could it be that spacers have been fitted, this I will have to check. What about the length of stud?
Regards

'84 1.9 LT25 Camper
I have alloy wheels and the studs on the rear wheels look too short. What should the length of studs be?
Thanks

'84 1.9 LT25 Camper
I'm not sure but I think that chrome bars were fixed to the roof above the cab. If anybody can confirm this can they advise where I can get a set from.
Regards