Club 80-90 Forums

Does anyone have experience fitting these hinges from NLA? Me and my Dad have spent two days fighting with it so far but cannot get it right. My mistake was probably to not buy the £250 bits of ply and try to do a homebrew job. Anyway as it stands the seat is fine and totally stable, the kickboard is at absolute right angles as shown by the repeating square pattern on the floor but when i pull the bed out it hovers on the slidey door side and puts big leverage on the hinges, plus it is starting to crush the top of the kickboard on the left of the picture.

It looks like another weekend of graft ahead to try and bring the right hand side forward where it fixes to the chassis. I can't understand why it would not be automatically straight though.

I don't really know my question, just any advice or moral support would be great. This is a total pig to fit.

Not sure, but this might help? Your hinges look too far forwards to me. Mine also has the bracket supports that rest on the top of the upright board
https://aircooledcommunity.com/wp-conte ... hinges.pdf
 

Have you tried speaking to Adam at NLA. In my experience they've always been approachable and pretty helpful.

Thanks, the instructions were worth a shot but the NLA hinges wrap over the top of the bulkhead and dont have the support for the bed overhang (it feels like a hell of a big overhang). But theyve got me thinking the side piece by the slidey door must be causing the levitation. I'll do some measuring. I've approached NLA but they don't have instructions.

Sent from my SM-G960F using Tapatalk

viewtopic.php?p=8322943#p8322943

Look on page 2 and you will see what I did to support the bed. 2 of us have been sleeping on it for the last 7 weeks not a bother. Hope this helps

I've realised i don't have this bit so will need to order it. A lot of the info seems to be for the T2 bed whereas i have the actual t25 one. I can't find a picture anywhere if how that's supported. Instructions definitely needed!

https://nlavw.com/trade-shop/index.php? ... er=product

Sent from my SM-G960F using Tapatalk

I’m interested in those hinges from NLA, the only ones listed are for the Type2, are those the ones you are fitting and do they also bolt to the engine bulkhead or just the 18mm wooden side sections?

 

I have these ones...
https://nlavw.com/home/724-t25-westfali ... inges.html

Sent from my SM-G960F using Tapatalk

They bolt downwards into the floor behind the bulkead as shown in the pics

Sent from my SM-G960F using Tapatalk

CoalMarx wrote: ↑06 Aug 2023, 13:16 I have these ones...
https://nlavw.com/home/724-t25-westfali ... inges.html

Sent from my SM-G960F using Tapatalk

So there are hinges for the Type2 and different hinges for the T25. NLA also list Springs and Supports for the T25 R n R bed, Are those essential as I cannot see them listed for the Type 2 RnR bed?

I can't comment as i don't know where the supports go!

Maybe someone on here has an original though and could send a piccy?

The supports seem to be fitted so that they rest on the vertical board and support the overhang. Might have to ring NLA up and ask them. Thanks......