Club 80-90 Forums

Hi Guys,

I am currently getting ready to convert my current MK1 GTI engine to a MK3 GTI. My current conversion was completed a long time ago by a previous owner back when these were not common so many of the parts are adhoc to say the least.

One issue I have is I am not sure where these engine bars / mounts are from:





At the moment they seem OK but I would like to know more about them so I can replace the rubber mount at some point.

More questions to come but thought I would start here

I don't recognize them, the ally bit looks the same but the steel mount is not similar.

But it looks like all the parts sit in the same place.

If you want I can take photos of the separted parts that I have ready for my transplant.

That would be great thanks.

I will take some more pictures tonight hopefully. I am hoping they will line up with the AGG as they are currently used on my MK1 gti 1.8 lump.

Also I think my exhaust mounts are 'bespoke' by the looks of it, do you have an image of yours?

Thanks again

I have yet to build my exhaust but it will be a VW Sharon downpipe from the manifold, into a Cat (must have over here), then into a flexi bit and finally into a Merc W124 back box side exiting in front of the offside rear wheel.

Titus A Duxass wrote:I have yet to build my exhaust but it will be a VW Sharon downpipe from the manifold, into a Cat (must have over here), then into a flexi bit and finally into a Merc W124 back box side exiting in front of the offside rear wheel.

For me I don't seem to have standard mounting brackets for the exhaust, so not sure what they should look like with my sump. I will upload pictures later

OK here are some pictures of my engine bars and mounts:

Offside









Nearside:









Not sure what best to do about these. I am hoping my AGG fits OK with them. Curious to know if they are fabricated or from a vehicle.

Also my exhaust mounts don't look OEM either:

Offside:





Nearside:







If anyone could shed some light on these that would be amazing, Thanks

Here's a link to a Google album - https://photos.app.goo.gl/71H8hojv5BepUmcR6" onclick="window.open(this.href);return false;

Is your MkII Gti mounted upright or at the 50* position the factory used for diesel engines? E D I T - I've now spotted the factory diesel sump in one of the photos so 50*.

The tubular parts of the engine mounts fit in the factory locations and I think might be the early diesel parts. The brackets welded to them for the rubber mounts I am not familiar with but they may be standard early parts.

The twisted steel strip connecting the ally mount arm to the sump is not factory nor appropriate. The sump thread normally carries the front end of a long triangular strip which picks up the other two bosses and then carries the metalastic exhaust mount at the back. The steel and rubber exhaust mounts shown appear custom made.

I suggest that you research the early, non-turbo, diesel mounts and exhaust to confirm that is what you have. If it fits the PB engine OK I think it will also take the AGG. You'll need new rubbers at the very least.

I would be interested in a couple of photos from above. Especially on the left side. Before I did my AGG conversion I considered the PB/MKI engine but found that it needed 'modification' to the nearside chassis rail to clear the inlet manifold. I would like to see what's been done with yours.

Are you aware of the Fb group 'VW T25 GTi conversion club' at https://www.facebook.com/groups/256191624580607/" onclick="window.open(this.href);return false; ? Lots of good info and answers there.

Hope this helps.