Club 80-90 Forums

hi big electric mirrors the wiring need help...
black/yellow wire pin G1 to drivers door mirror switch then black,blue ,white to mirror and brown to earth..so does the passenger side ie blue/black,black ,white then run though rubber boot and back up drivers boot to switch??

i bought a bluestar central lock loom with boots so central locking ,speaker,electric mirrors or windows and colours ???different 3way block colours are black/yellow,yellow,black/ red..the black/yellow and yellow into 2way block and black/red spilts into 2way block shared with brown and then off to an other 2way block with black/red and brown the same on both door looms?? thanks

simon

As posted on the BY http://www.brick-yard.co.uk/forum/looms ... 62777.html

thank paul ive seen that one mate today its just the loom and the wires ie colours what are they for?? and still need to make front loom from fuse box to both doors thanks any help with the loom ive got... what colour for what and plugs in will help many thanks

simon

Do you not have the middle wiring loom that would be under the dash ? There are LHD and RHD versions.

no just the wiring with the rubber boots onwards and pictures ??? drawings of what is needed will help

simon

I will have a look at the rhd middle loom I will be fitting to my van, will report back later.

Looks a bit complex ! lots of connections for the complete door loom set up, maybe a simplified version as suggested above if its just the mirrors you want to power. There is wiring diagrams for the mirrors and windows etc in the Bentley manual .

if your loom is lose can you take some pictures ....
so your door looms you have brown/blue and blue for speakers then
4way for central locking
3way black/yellow and yellow then black/red??? whats that for then anyone??
2way yellow/black , yellow??
2way black/red and brown into 2way block twice??
anyone

simon

I've got the circuit diagram for electric mirrors on South African vans, the colours are different but it shows the interconnections. Each mirror has wiring for the adjustment motor, the solenoid which switches between vertical and horizontal adjustment, and the mirror heating element.
It looks like the three way connectors take the power to the motors and solenoid and the return from the motors, the two way connectors take the power to the heating elements and the returns from them and the solenoid.
The three way connectors then go to the switch.

Thanks mirror wiring sorted and speakers the looms I have is for windows but the colours not quite right will sort one day

Simon

If you pm me with your email address I will send you a photo of the RHD middle wiring loom.

I need help with this guys.
I have bought some mirrors with the loom hanging out the bottom of each mirror and an electric mirror switch.
The wires have spade connectors on them and appear uncut and original.
Any help just getting the mirrors operational?
Heating and electric would be ace.