Club 80-90 Forums

Hi looking for some advice please
Can I fit a set of alloy wheels that have fitment for a T4 to a T25

Heres the spec on the wheels

Material Alloy
Rim Diameter 17 inch
Rim Width 8J
Offset 35
Stud Diameter 112
Number of Studs 5

Would adapters etc be required

I would appreciate any advice,
but please, Im not a techie, so explanations in plain English please ............. as I wouldnt want to ask a further 50 questions on what the answers mean
Many thanks

You'll most likely need a 5mm spacer at the front to clear the suspension on full lock, and you may want a 10mm spacer (and therefore longer studs) at the back to even things out visually.
Anything significantly more than this and you start affecting geometry...

Center bore for T4 was 57,1mm, the T25 requires 66,5mm

That's a lot of metal to remove.

More than I'd feel comfortable with

I have bored out a few wheels. If any come in that look like they will be sketchy after machining I refuse to do them.
Pics of the hub side of the wheel centre with a tape measure in shot might help here.