walkthrough van conversion
Posted: 05 Aug 2014, 21:18
Hello dubbers
I would be extremely grateful for any advice on this!!
I have recently bought a 1986 panel van 1.9dg .
Now I say panel van the thing is the entire drivers side (not cab or back post so entire side is inaccurate ) has been cut away and a caravelle side welded in (same colour believe it or not) so.I.am doing a conversion to a camper at the moment the van has bench seat and drivers seat but I am wanting to fit captains seats on swivels .the problem.is there is a bulkhead? I think that's right? Behind seats and the bench middle seat is supported via a bracket if I remove seats can I.just cutaway this "bulkhead "? And how would I finish or trim.it near the cargo floor pan? Any one else successfully removed said bulkhead to make van a walk through model? Thanks in advance
P.s will.try upload pics
I would be extremely grateful for any advice on this!!
I have recently bought a 1986 panel van 1.9dg .
Now I say panel van the thing is the entire drivers side (not cab or back post so entire side is inaccurate ) has been cut away and a caravelle side welded in (same colour believe it or not) so.I.am doing a conversion to a camper at the moment the van has bench seat and drivers seat but I am wanting to fit captains seats on swivels .the problem.is there is a bulkhead? I think that's right? Behind seats and the bench middle seat is supported via a bracket if I remove seats can I.just cutaway this "bulkhead "? And how would I finish or trim.it near the cargo floor pan? Any one else successfully removed said bulkhead to make van a walk through model? Thanks in advance
P.s will.try upload pics