Has anyone fitted their own table base between the seats?
It was easy enough to fit the rear one as I could see where i was drilling.
But under the floor between the seats is cluttered with pipes/crossmembers etc.
Also how did you screw it down? it's just thin steel under there, no wooden floor.
Fitting table base.
Moderators: User administrators, Moderators
- bigbadbob76
- Registered user
- Posts: 1733
- Joined: 07 Nov 2016, 14:41
- 80-90 Mem No: 15707
- Location: Isle of Skye
Fitting table base.
'86 1.9 DG, 4 spd, tintop, camper conversion.
Split case club member.
Split case club member.
- itchyfeet
- Registered user
- Posts: 12427
- Joined: 23 Jul 2007, 17:24
- 80-90 Mem No: 12733
- Location: South Hampshire
Re: Fitting table base.
There is one in my van fitted by holdsworth
my guess is they didn't drop the tank
drill carefully with a hole saw you can drill a pilot hole and then use a short stud in place of a drill to limit chances of the drill damaging anything.
Self tappers into steel are plenty
Need a pic?
my guess is they didn't drop the tank
drill carefully with a hole saw you can drill a pilot hole and then use a short stud in place of a drill to limit chances of the drill damaging anything.
Self tappers into steel are plenty
Need a pic?
- bigbadbob76
- Registered user
- Posts: 1733
- Joined: 07 Nov 2016, 14:41
- 80-90 Mem No: 15707
- Location: Isle of Skye
Re: Fitting table base.
Aye, if you could post a pic showing where yours is so i know where to drill to be safe that'd be great, cheers.
Countersunk self tappers on order.
Countersunk self tappers on order.
'86 1.9 DG, 4 spd, tintop, camper conversion.
Split case club member.
Split case club member.