Fitting longer rear studs

[kit]

I have got myself a couple of rear hubs with standard studs and I was going to fit longer ones and then replace my hubs, I found removing the studs fairly straight forward using a ball joint splitter and was wondering if anyone had ever pressed in new ones using a similar method as I don't have access to a press I was thinking this might be an option?

[ELVIS]

Go to your local friendly garage that you use, smile sweetly and ask to make a contribution to tea boat.
It's a job that takes ten/fifteen minutes.
Get em pressed in. Do it once, do it properly

[weegaz22]

I would try to use a large long reach socket slipped over the stud and use an old wheel nut to pull it into the hub if no access to a press

[Titus A Duxass]

I would try to use a large long reach socket slipped over the stud and use an old wheel nut to pull it into the hub if no access to a press

Winding them in with a wheel is not acceptable.

[silverbullet]

I have a pair of totally f***** rear hub flanges at work, "fitted" with long studs. They are actually wavy, and I dont mean by a few thou' either!
I imagine they got in such a state by someone struggling to fit the studs by the "pull 'em in" method.
Considerable force is required to fit aftermarket wheel studs, the knurling behind the head is a lot coarser than that on the original studs.

Sent by Morse code from the bunker

[ELVIS]

Forgot about them, they came from the Danish Slambulance I bought and broke about three years ago IIRC.

[silverbullet]

I do believe that the BW shop pages for wheel studs do have a word or three to say about correct fitting

Sent by Morse code from the bunker

[Itsblue]

i Removed and refitted my studs this week , white overhauling the rear trailing arm , when i came to refit the studs i poped the stud in the hole
using the wheel nut tighted it as far as it was possible to pull it in , the took the hammer to the back side and hammered it all the way in , pretty easy

[kit]

Just re read the instructions on the Bricwerks page and if I read correctly it says you can hammer them in?

[kit]

Finally got them last week

[what2do]

i Removed and refitted my studs this week , white overhauling the rear trailing arm , when i came to refit the studs i poped the stud in the hole
using the wheel nut tighted it as far as it was possible to pull it in , the took the hammer to the back side and hammered it all the way in , pretty easy

Nobody said it was difficult. The problem with this method is it comes with risks.