anyone any ideas on our 1986 T25 syncro 2.1 DJ
Had several issues with the speedo cluster (lights lighting for no reason etc and I have made a repair to the circuit tracks so everything works but one problem remains
Sometimes the water level/temperature red warning light flashes after the engine warms up. On cold start its alright but when engine is warm it seems to come on . the only way to clear it is to disconnect the temperature sender wire underneath the engine and put it back on.
Any way just to be sure I have
1)replaced the temperature sender
2)replaced the water level sender
3) put switch cleaner on the two 7 pin multi connectors in the engine junction box and re connected as these take the feeds from sender and level sensor.
4) have pulled and put back relay 3 (number 43) in the fuse box which is the water level switch relay but have not replaced it yet.
What works
Everything including temperature gauge, and Fuel gauge (and sometimes no flashing red water level light!!!)
I suspect the voltage stabiliser may be at fault or broken track again in the ribbon cable so can someone confirm if the voltage stabiliser is one of the flat transistors on the ribbon cable at the back of instrument cluster or any have any other ideas. Cant see anything else in the circuit diagram on Bently.
cheers
Kevin
water level red falshing light
Moderators: User administrators, Moderators
- Aidan
- Trader
- Posts: 6556
- Joined: 11 Oct 2005, 19:21
- 80-90 Mem No: 742
- Location: Llanfyllin, mid Wales : )
- Contact:
Re: water level red falshing light
voltage stabiliser is the black three legged component on the back of the rev counter
- marlinowner
- Registered user
- Posts: 1530
- Joined: 28 Jan 2014, 12:02
- 80-90 Mem No: 13646
- Location: Scottish Borders
Re: water level red falshing light
When I had a bad earth to the instruments the temp warning light flashed when the engine was slightly warmer than usual (before the radiator fan came on).
1993 SA VW T25/T3 2.5i Microbus/homebrew camper
1981/1968 Marlin Kitcar TR6 Engine
1981/1968 Marlin Kitcar TR6 Engine
-
- Registered user
- Posts: 1931
- Joined: 21 Feb 2012, 21:47
- 80-90 Mem No: 0
- Location: lancaster uk
Re: water level red falshing light
Have you looked at the connectors on the relay plate back itself?
-
- Registered user
- Posts: 156
- Joined: 27 Feb 2007, 23:05
- 80-90 Mem No: 11858
- Location: Oswestry, Shropshire
Re: water level red falshing light
Sounds like a bad earth.
Have you checked your earth strap from the engine to the chassis?
I had a similar thing on mine and decided to ignore it. Then one day it overheated because it was low on coolant!!
Have you checked your earth strap from the engine to the chassis?
I had a similar thing on mine and decided to ignore it. Then one day it overheated because it was low on coolant!!
- syncro4us
- Registered user
- Posts: 117
- Joined: 07 Jun 2006, 07:27
- 80-90 Mem No: 2677
- Location: Chester Club80-90 membership No 2677
Re: water level red falshing light
Aidan wrote:voltage stabiliser is the black three legged component on the back of the rev counter
will check this out and see also earth connections
Kevin