Afternoon all,
The girlfriends "new" van requires the side windows taking out, the rust removing and repair patches welding in. My question is fairly simple if I buy new seals how much longer than the circumference of the window do I need to make the new seal. The seals fitted currently are neither the correct ones or the correct length (1" gap at the top!). I seem to remember from when I did some back in the day that it was around 1.5" longer. But, I cannot find anything to substantiate this on the world wide webs!
Thanks in advance
Richie
Panel van side windows
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 54
- Joined: 03 Jun 2009, 21:41
- 80-90 Mem No: 6900
- Location: South Witham, Nr Grantham
Panel van side windows
1982 Leisure Drive hi-top 1.9 N/A 1Y.
http://www.justgiving.com/Richard-Adkins/
http://www.justgiving.com/Richard-Adkins/
- bigbadbob76
- Registered user
- Posts: 1733
- Joined: 07 Nov 2016, 14:41
- 80-90 Mem No: 15707
- Location: Isle of Skye
Re: Panel van side windows
I'd allow for several extra inches and cut it to size once you put the seal in.
It can get a bit stretched during fitting and then shrink back leaving the gap you mention.
It can get a bit stretched during fitting and then shrink back leaving the gap you mention.
'86 1.9 DG, 4 spd, tintop, camper conversion.
Split case club member.
Split case club member.
-
- Registered user
- Posts: 1824
- Joined: 10 May 2013, 11:59
- 80-90 Mem No: 13706
- Location: Central Scotland
Re: Panel van side windows
I recall leaving an overlap of maybe a half inch, and finishing by forcing them in to butt against each other. Long term I think the rubber shrinks, and this lets it shrink without tapping. Also if you have seals with an internal trim strip the seal join should be at the bottom of the window (as always), and the trim strip join should be elsewhere, to help align the seal joint. Use the proper tool for the trim strip, and soapy water to fit the trim strip. A windscreen sealant such as arbomast autograde is also good belt and braces for a new seal.
Have you ever seen an unhappy fool?
88 Transporter with hitop camper conversion, 1.6td.
88 Transporter with hitop camper conversion, 1.6td.
Re: Panel van side windows
RogerT wrote: Also if you have seals with an internal trim strip the seal join should be at the bottom of the window (as always), and the trim strip join should be elsewhere,
I've just bought new seals for mine and was watching the demo video on seals direct - they say the join should be at the top?
https://www.youtube.com/watch?v=RuIRUaUrVFI
1990 1.9DG 34DAT carb Leisuredrive hightop