I managed to break one of these M8 bolts (with a flat head) off this diesel engine mount/chassis rail.
Brickwerks said they didn't have any, so I just ordered some of their high grade M8 bolts. Looks like i might need to shave the head down so it mounts properly. I wasn't sure if that was 100% safe though. Thoughts?
Cheers,
HC.
Engine Mount/Chassis Rail Bolt
Moderators: User administrators, Moderators
-
- Registered user
- Posts: 328
- Joined: 03 May 2017, 00:19
- 80-90 Mem No: 16820
- Location: Cheshire
Engine Mount/Chassis Rail Bolt
1984 Autosleeper, pop-top, 1.7 KY, 5-Speed
- tobydog
- Registered user
- Posts: 1384
- Joined: 07 Mar 2009, 21:03
- 80-90 Mem No: 6484
- Location: Near Saarfend, Essex
Re: Engine Mount/Chassis Rail Bolt
What is the thread length? I might have some 12.9 Unbrako cap heads lying around....
Knowledge is power
1970 CU
1970 CU
-
- Registered user
- Posts: 328
- Joined: 03 May 2017, 00:19
- 80-90 Mem No: 16820
- Location: Cheshire
Re: Engine Mount/Chassis Rail Bolt
I think they are about 30mm, Toby. I can measure in the morning.
1984 Autosleeper, pop-top, 1.7 KY, 5-Speed