Final drive sump torque setting

Post by **Ciaoflyer** » 23 Jun 2019, 13:53

Anyone know correct torque setting for the sump on final drive attached to auto box? Ta

Post by **937carrera** » 23 Jun 2019, 14:17

Any use ?
.

: diff_sump.jpg (88.79 KiB) Viewed 882 times

Post by **Ciaoflyer** » 23 Jun 2019, 15:57

937carrera wrote:Any use ?
.

diff_sump.jpg

Perfect but what is the bit about 5 mins?

Post by **937carrera** » 23 Jun 2019, 16:02

Zoom in, it says "Tighten diagonally, retorque twice more after intervals of 5 minutes"

Post by **Ciaoflyer** » 23 Jun 2019, 16:15

937carrera wrote:Zoom in, it says "Tighten diagonally, retorque twice more after intervals of 5 minutes"

Super, so does that mean a total of 21ft lb?

Post by **937carrera** » 23 Jun 2019, 16:19

Not my reading.

Torque diagonally to the 10NM.

Let it settle for 5 minutes, then go around again at the same setting

Repeat.

I don't even have a torque wench that goes that low, and I have 4 of 'em

Post by **bigherb** » 23 Jun 2019, 16:46

Yes it means to recheck torque again after 5 mins as the gasket will settle.

Post by **Ciaoflyer** » 23 Jun 2019, 18:05

Thanks so much guys!

Club 80-90 Forums

Final drive sump torque setting

Final drive sump torque setting

Re: Final drive sump torque setting

Re: Final drive sump torque setting

Re: Final drive sump torque setting

Re: Final drive sump torque setting

Re: Final drive sump torque setting

Re: Final drive sump torque setting

Re: Final drive sump torque setting