DJ 2.1Auto Injection stalling issue.

Big lumps of metals and spanners. Including servicing and fluids.

Moderators: User administrators, Moderators

Post Reply
User avatar
maxstu
Registered user
Posts: 4474
Joined: 07 Feb 2008, 01:05
80-90 Mem No: 3946
Location: Margate

DJ 2.1Auto Injection stalling issue.

Post by maxstu »

Symptoms are immediate engine shutdown either when driving or standstill idling. So in my opinion electrical and not fuel. Can happen two or three times in five miles. Always restarts though. Is this the famous westy cough?
First checks were leads and out of interest plug removal. Considering this is warm up period first thing early morning plug is very lean looking to me. And recent MOT emissions read:
CO=1.26% ......max 3.50
HC=57PPM....max 1200.


Image
Where do l start? Check timing?
Check idle stabiliser? Earth wires in engine compartment?
ECU? Mine is jammed ......ie not mounted... between coolant tank and bodywork left of access flap :shock:
Your advice please?
Regards
Stuart
MaxStu
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
"Blissfully happy in your presence".

User avatar
937carrera
Registered user
Posts: 3599
Joined: 05 Apr 2015, 19:29
80-90 Mem No: 16333
Location: N Yorks.

Re: DJ 2.1Auto Injection stalling issue.

Post by 937carrera »

Check all earths by all means.

I can only offer generic advice, others will have more specific DJ experience, there might be a well known fault, hopefully

Sounds like it could be a break in a wire within a loom / connection braking down under heat. Pull all connections for ignition feed, fuel pump, ecu etc, make sure they are clean and then be prepared to spend lots of time wiggling cables with the engine running. Read the wiring diagrams too.

Intermittent problems are a right pain.

oh, and get that ECU mounted properly
1981 RHD 2.0 Aircooled Leisuredrive project, CU engine
1990 RHD 1.9 Auto Sleeper with DF/DG engine

User avatar
maxstu
Registered user
Posts: 4474
Joined: 07 Feb 2008, 01:05
80-90 Mem No: 3946
Location: Margate

Re: DJ 2.1Auto Injection stalling issue.

Post by maxstu »

Hi Carrera,
Yeah! Thanks. Now had engine idling for ten minutes until fan kicked in without any issues. It does cough a little when fan cuts in and out and apart from getting a wee shock from alternator cable :shock: all seems fine.
Found dislodged wire on power steering pump too. And petrol cap letting out fumes? Is that normal in hot weather?
Whats your view on plug colour?
Thanks
Stuart
Just about to press send and bugger cuts out :roll:
MaxStu
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
"Blissfully happy in your presence".

User avatar
937carrera
Registered user
Posts: 3599
Joined: 05 Apr 2015, 19:29
80-90 Mem No: 16333
Location: N Yorks.

Re: DJ 2.1Auto Injection stalling issue.

Post by 937carrera »

It's not unusual for revs to drop momentarily when the rad fan cuts in, especially if it's a high powered fan.

Petrol cap shouldn't be letting out fumes. It'll likely be the usual breather pipe issues, but if you have done those check the seal on the tank cap and the plastic pipe to the tank.

Plug colour looks ok to me, always greyer on modern engine management systems
1981 RHD 2.0 Aircooled Leisuredrive project, CU engine
1990 RHD 1.9 Auto Sleeper with DF/DG engine

User avatar
Aidan
Trader
Posts: 6522
Joined: 11 Oct 2005, 19:21
80-90 Mem No: 742
Location: Llanfyllin, mid Wales : )
Contact:

Re: DJ 2.1Auto Injection stalling issue.

Post by Aidan »

ignition switch ?
how many keys on the bunch

User avatar
maxstu
Registered user
Posts: 4474
Joined: 07 Feb 2008, 01:05
80-90 Mem No: 3946
Location: Margate

Re: DJ 2.1Auto Injection stalling issue.

Post by maxstu »

Aidan wrote:ignition switch ?
how many keys on the bunch
Cheers guys. Good question Aidan. This amount


Image

I do have a new switch...might give it a go.
MaxStu
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
"Blissfully happy in your presence".

User avatar
tonytech
Registered user
Posts: 1194
Joined: 11 Oct 2005, 06:40
80-90 Mem No: 477
Location: Liverpool

Re: DJ 2.1Auto Injection stalling issue.

Post by tonytech »

Two years since I let my van go to the great recycling centre :( So I cant help much, but if your ecu is just wedged in is it getting a good earth?
I remember the harness has multiple earths around the engine bay, but does the ecu case also act as an earth? Even if the case only acts as to screen the internals from the electrical noise of the enging bay it may cause intermitant problems.

T
There are 10 kinds of people. those who understand Binary and those who dont

User avatar
maxstu
Registered user
Posts: 4474
Joined: 07 Feb 2008, 01:05
80-90 Mem No: 3946
Location: Margate

Re: DJ 2.1Auto Injection stalling issue.

Post by maxstu »

Hi Tony,
Good point. Ill try and return to engine bulkhead...
:ok
MaxStu
1989 DJ 2.1 Auto Leisuredrive rusty bucket.
"Blissfully happy in your presence".

Post Reply