Hi,
When flushing through the brake and clutch fluid should I bleed the brakes first or the clutch cylinder first? Going with the logic of furthest from the master first I'm thinking rear brakes, clutch, front brakes.
This is probably a simple question but I've had a good search on the wiki and forum with no luck.
Cheers,
Matteo
bleed brakes before clutch?
Moderators: User administrators, Moderators
bleed brakes before clutch?
1980 2l CU Aircooled; left-hand drive - now officially a historic vehicle!
- itchyfeet
- Registered user
- Posts: 12427
- Joined: 23 Jul 2007, 17:24
- 80-90 Mem No: 12733
- Location: South Hampshire
Re: bleed brakes before clutch?
brakes and clutch are entirely separate circuits only sharing the same top up tank so you can do them either way.
Re: bleed brakes before clutch?
Ah I see! Thanks, I'll get going with this job this now (in the rain) At least it will be dry underneath!
1980 2l CU Aircooled; left-hand drive - now officially a historic vehicle!
Re: bleed brakes before clutch?
Hi , From memory it goes back offside, back nearside, front offside , then front nearside. It's fairly easy with one of those vacuum bleeder efforts one person job then ( note if you do use a vacuum bleeder , I put a bit of PTFE tape around the bleed nipple thread while getting the fluid through or else it draws air from that joint, having said that I had completely no fluid in the system prior to putting the new fluid in) hope this helps
- itchyfeet
- Registered user
- Posts: 12427
- Joined: 23 Jul 2007, 17:24
- 80-90 Mem No: 12733
- Location: South Hampshire
Re: bleed brakes before clutch?
mrdp wrote:Hi , From memory it goes back offside, back nearside, front offside , then front nearside. It's fairly easy with one of those vacuum bleeder efforts one person job then ( note if you do use a vacuum bleeder , I put a bit of PTFE tape around the bleed nipple thread while getting the fluid through or else it draws air from that joint, having said that I had completely no fluid in the system prior to putting the new fluid in) hope this helps
why vacuum bleeder pressure bleeder is surely easier?