Can anyone confirm - 1.9/2.1 manifold differences

[ash1293]

I've been having a bit of a look around and I'm trying to find a definitive answer on differences between late 1.9 and 2.1 exhaust manifolds.
While I am considering a custom stainless system in the future it seems a shame at the present as the silencer and link pipe back to the knuckle are relatively new. 1&3 pipe is decidedly dodgy and will be in need of repair or replacement while 2&4 may patch ok.

I can't see any reason non syncro 2.1 manifold pipes should fit the 1.9 but if anyone can confirm that would be great.

[Mocki]

There is no difference , other than the lambda probe port if injection , which can be blanked if not used in the intermediate pipe , other than that all exactly the same

[ash1293]

There is no difference , other than the lambda probe port if injection , which can be blanked if not used in the intermediate pipe , other than that all exactly the same

May risk a klarius 1&3 as seen as low as £63

[ajsimmo]

The main difference is that on the carb version (therefore 1.9) the 1&3 side has an air intake preheater around it for the airbox to draw warmed air in very cold climates (helps cold running/anti carb icing). Not needed on injection models, or even carb models in our climate for that matter. So either version will fit either engine.

[itchyfeet]

There is no difference , other than the lambda probe port if injection , which can be blanked if not used in the intermediate pipe , other than that all exactly the same

May risk a klarius 1&3 as seen as low as £63

Some of the really cheap ones are a rubbish fit, tried one from eurocarparts sent it back, it had no bracket under bellhousing and would have touched gearbox.

[ash1293]

Cheers, will keep that in mind