Hole size and location for loom - Subaru Conversion

for questions and answers about alternative power transplants on the T25, GTi, Porsche,Subaru etc, this is the place. You must register to post but anyone can read.

Moderators: User administrators, Moderators

Post Reply
matt brighton
Registered user
Posts: 643
Joined: 19 Apr 2010, 08:22
80-90 Mem No: 8092
Location: brighton innit

Hole size and location for loom - Subaru Conversion

Post by matt brighton »

Hi

What size hole and where did you locate the entry point for the ecu etc under the rear seat ?



I think Richard suggested 56mm nearside of the panel under the R&R seat

Photo would be helpful as i hope to get the hole saw out today and bolt in the ecu and relays inside the van

Thanks

Matt
Last edited by matt brighton on 12 Sep 2018, 19:18, edited 1 time in total.

multisi
Registered user
Posts: 1724
Joined: 03 Apr 2016, 12:01
80-90 Mem No: 12
Location: jersey

Re: Hole size and location for loom - Subaru Conversion

Post by multisi »

About half way between van centre and nearside above the area that sticks out there is a smooth area . You may find a dimple for the location of the hole centre but not sure if the early models had this pressed in to the panel.
1992 red lle 2.2 subaru 1990 rhd caravelle 2.2 subaru 1986 california import vanagon

matt brighton
Registered user
Posts: 643
Joined: 19 Apr 2010, 08:22
80-90 Mem No: 8092
Location: brighton innit

Re: Hole size and location for loom - Subaru Conversion

Post by matt brighton »

Thanks

Its reassuring to have that confirmed

Matt

Post Reply