Club 80-90 Forums

Have at long last found my coolant light problem is electrical. Having renewed level sensor and temperature gauge sender . I find that if i turn the ignition on and leave for a few seconds the red light will go out on starting even when hot .Temperature gauge shows just passed the red light when run...

Have now bleed the system again . Header tank was full but got some more air out. lights once again out on starting warm . I had replaced the Dalek cap from Just Kampers and that still quacks when tested today. The recon engine was replaced in December through Just kampers and is still under warrant...

Thank you all for your answer to my coolant problem. Well i ran the van up the road and got it running temperature, rev the engine up and removed coolant cap. collant still up to neck so a bit more revs , now as you said air bubbles appear. keep this up topping up tank all the time . water now overf...

Hi Angloeves Have now fitted new 43 relay and the problem is still the same ok when starting from cold. but once slightly warn led light flashes . I will check the earth on the pillar next to fuse box. I was thinking of earthing out the gauge itself even though it working . i was wondering if its se...

Thank you Angeloevs I have now replace both coolant level sender and Temperature sender. Have check voltage stabilizer and earth and wiring . all working . So have put the trouble down to a 30 year old coolant relay switch sticking. As the light goes out when engine is cold and stays on when warmed ...

Can any one help. Coolant light work ok when starting from cold . But when hot even though all temperature and sender's replaced . Light stays on when warmed up . system bleed and gauges working while light flashing. not overheating or using water . any ideas.
Hugo 1988

Well i have changed my voltage stabilizer with a new three pinned 1A 10v LM2940T. And guess what it's made it worse. Now instead of showing 3/4 it goes right across to the right. even after a very few miles.And i know the engine is not hot. Fuel gauge seems to be steady . Has anyone got an idea as t...

Thank you for your replies regarding my voltage stabilizer. I have now purchased a 3 pin 1A 10v LM2940T-10.0 i will be fitting this shortly to see if this hopefully cures the problem . i will let you know at a later date . Hugo1988

I have purchased a 1988 T25 camper van . In June last year. I have just replace the engine but find the engine runners at 3/4 on the temperature gauge. I have replaced the temperature sender, and the thermostat it made no difference. Having read that the voltage stabilizer controls the temperature a...