Club 80-90 Forums

or you could just get some black plastic covers that you find on most recent VW's

marlinowner wrote:Here's a picture of the nuts on my Atiwe wheels, one is missing the cap - the stud is down in the shadow somewhere...

Can you still get the cover caps??

Fozzie, and your L/H/D lamps are perfectly legal (will pass the MOT) as long as beam deflectors are correctly fitted and don't effect the light intensity significantly. The most common complaint from owners is that the lights just aren't bright enough and this is usually fixed by fitting relays wit...

Are rhd square headlamps a direct fit for left hand ones?
And would the only benefit fitting them on a lhd vehicle be that you don't have to put on the beam deflectors?

thanks for all the help does anyone know if you can still get the silver caps that go on the end?

Nope that is not safe. You may have the incorrect nuts, what face do they have (radius or cone)? Steel wheel nuts have radius and the carats have cone. Those nuts do not look like they have 7 turns engaged. Have you got the wheels sat on the hubs correctly, make sure that they are not sat on the tw...

Just fitted a set of carat alloys which came with all the original wheel bolts/nuts fronts were fine the rears fit but after tightening them up there is still a lot of thread on the nuts that is not being used see picture. Is this ok/safe or do I need to change anything? http://i2.photobucket.com/al...

Hi people,

What's is the best thing to use to clean the pop top canvas on my westfalia california?

Hi, welcome to the forum. You can fit three point belts into the rear. https://www.brickwerks.co.uk/rear-seatbelt-kit-t3.html You can also fit isofix mounts. We recently put a car seat into the back and had three point belts fitted. its a pain if you want to regularly roll the bed out because getti...

Ahhhh! worth a try mate. Yes the large 'under-step' box houses all the gubbins .. the two large pipes going to the rear of the box are air supply and heat into the van (the cold supply, which is drawn from inside the van, also carries the wiring to the blow heater) The glowplug/igniter can just be ...

Right thanks a lot for the replies so far I'm determined to fix this as I get the feeling it's not anything major I have just been and removed the silver box and removed the fuse which doesn't look like its blown see pic below I was sort of hoping it was but looks fine to me. Where is the blower you...

Right the latest update is I tried with the engine running and still the same I switch to hot turn dial to 7 starts up and then turns off after 20-30 seconds when it turns off it makes a noise which I can only describe as a sort of squeaking noise does anyone know what this could be? I've not checke...

Hi Fozzie....have you checked the fuse in the bottom of the control relay? situated next to the black box (charger) I think you have to remove some woodwork to access but the 'large' control relay has a small glass fuse in its base. The other point is that the ebber draws around 8 amps when in its ...

No ignition, so it purges the combustion chamber for half a minute. Pump pumping fuel? Glowplug glowing? Sorry I'm a bit of novice when it comes to these it starts up and stops after about 30 seconds i know that, how will I know if the pump is pumping fuel or if the glow plug needs changing? Thanks

Thanks for the replies, on the control panel I press the switch to the right (heat) and turn the dial to 7 I hear something starting up and then after about 30 seconds it turns off but the green light still remains on the control panel any ideas??
Thanks