Club 80-90 Forums

I need help with this guys.
I have bought some mirrors with the loom hanging out the bottom of each mirror and an electric mirror switch.
The wires have spade connectors on them and appear uncut and original.
Any help just getting the mirrors operational?
Heating and electric would be ace.

Its all about helping each other, put the effort in for those in need. So you can see the set up now as done at the factory, you can fabricate those extra brackets to get the position 80 mm towards the front of the van . You will need the correct pin though, put up a photo of what frank is giving y...

Removed bed and plastic side on my factory multivan to show you bracket set up. The measurements are sliding door side, C post edge to pin centre 615 mm. Boot floor with factory sound proofing to pin centre 372 mm. Other side B post to pin centre 1765 mm . The middle bracket the pin goes in is 21 m...

Multisi

Any help and measurements etc would be fantastic.
I have access to a welder and my dad (retired) was a welder fabricator his whole life so he will be enlisted

All the bolt holes should already be there - the important thing is that you have the correct locking pins (for the rear seat rest). If they're too short to reach the seat, then they're the wrong ones. You'll also have gaps at either side, but it sounds like you know that already. Only the bolt hol...

It does come with all the fixings and I can see in the image it has some square box looking things with threads for the pins to screw into I am hoping these are the spacers for the pins Those square box things,you should have 4 are for the rnr mechanism, they screw into the side of the van. Then th...

KarlT wrote:lovely. needs a subaru now. mmmmmmm!

It will run a ej25 at some point but it's such a sweet little lump in it now that I won't change until it dies....was considering a turbo Subaru but you have to hack some chassis bits away and the gearbox is always a tricky one.

Thanks guys.
It's the 1.9dg petrol. It wanted for nothing in its life and the old boy had Volkswagen fit a brand new engine 3 years ago it's covered 19000 on this engine.
She purs like a kitten dogleg 5 speed .

Very nice , if you need original grey material ( UG1 ) vwbusshop.de has some in the form of a upper bed cover,they are stored folded so have creases but will help to make a better cover for your multivan bed. They also have the seat base cover in that material for multivan width not the backrest th...

It does come with all the fixings and I can see in the image it has some square box looking things with threads for the pins to screw into I am hoping these are the spacers for the pins

All the bolt holes should already be there - the important thing is that you have the correct locking pins (for the rear seat rest). If they're too short to reach the seat, then they're the wrong ones. You'll also have gaps at either side, but it sounds like you know that already. Cool thanks man I...

multisi wrote:Are you getting the backrest lock pin brackets with the seat bed.

Yes it comes with all the original fittings.

Hi guys Finally gonna pick up a factory multivan bed to bolt into my pride and joy 1 previous owner velle :D I know it's a little narrower but I will have some cushions made from the original material from the existing seats that are coming out. How sexy is this van....if I do say so myself. This ol...

Hi guys,
I know the multivan bed is slightly narrower but I am buying one from a member on here.
Any pointers on how I go about fitting it into my lovely velle?
Many thanks.