Club 80-90 Forums

Ni mind, he'll be back when he wants sumat, don't let em grind you down Steve, we need you & your knowledge on here more than them

"But if you're actually in Brazil,as your username suggests,I doubt load ratings will matter?"

I think he's actually in sheffield Steve ! A fellow Yorkshireman

The centre bore may need enlarging from 57.1mm to 66mm. Longer rear studs. Longer front bolts(or stud conversion) Spacers...the thickness of the spacers depends on the actual offset though as the seller isn't sure,but if they are ET45 you'll need 15mm spacers to bring the offset down to ET30. Make ...

Hi, this is my 86 single cab, bought off the scrap man, for its value in scrap !, he'd been given it for scrap by the previous owner, after seeing it in his front garden, & knocking on his door, the scrap man had filled it up with scrap, ready to tow into the scrapyard when I spotted it This is ...

mimiwestfalia wrote:I have same, but my pantas are 16x8J

Looks good on the deeper dish, nice looking van mate

Just hand polished em with peek polish !

Thanks, I was damned lucky tbh, someone gave me three different sets of alloys for scrap, amongst them were this set of five pentas, so I refurb end them myself, cost me a set of load rated tyres & a stud kit !! Well happy http://i864.photobucket.com/albums/ab208/paulggrice/aea6807e35cac154f4430...

The bit I missed off the last post

All done with the knowledgable advice of Steve (g60steve), he is a true expert on all things wheels !

^^^^^^^^^^^ mine in the previous post, are Ronal amg 7.5x16H2 et42' I needed 15mm spacers on the front, so did the same on the rear to keep the same, longer studs on rear, plus longer stud conversion on the front, then fitted these van rated tyres, to keep the rolling circumference the same as the o...

This is mine, more info on my other posts about pentas, but mine are 7.5

Baby moons with off white steels on my pick up

Stanman If your existing rail is tidy, I'd be tempted to leave it on, as you will see, mine is on the lip of the moulding, when my awning is fitted on the rail, it just sits above the gutter, some people mount there rail a bit higher, but I fitted mine there, so it blends into the roof better, peel ...

Nice job. Nice bus. HOW often do you polish them? Our roads down here must be full of aggressive contaminants. I have to polish mine very regularly as they taint easily. I've used Maas, Belgum Alu, etc. all the same. Brasso/Silvo help make it easier. One wheel is lacquered. Oh joy! (Wash & Go) ...

Me Ning ?, I just re polish mine as & when, just when they start looking abit grubby :( , & soz, I said I used autosol, it's actually peak I use, just polish the rims up with peak, then that's it, don't put not else on, bit of elbow grease, but a couple of hours work & they're like new a...

You need to fit what I think is known as "p section", or could be "b section" !!, depends which way you look at it, I got this angled profile, as it sits just nice on the angle of the moulding on the trident roof, plus I fitted it end to end, & angled the ends, as opposed to ...